This adapter allows the installation of the VW TDI engine to a Nissan transmission. It uses the stock Nissan flywheel and includes a high torque mini starter.
The adapters are not transmission specific, they make the back of the TDI "look" like the back of the engine that the TDI is replacing. The adapters can be used with standard transmissions. 2WD or 4WD.
The adapters are not transmission specific, they make the back of the TDI "look" like the back of the engine that the TDI is replacing.
The adapters can be used with automatic or standard transmissions. 2WD or 4WD.
This billet aluminum housing has provisions for main oil out and return (ORB-6 threads) as well as turbo line in the stock location along with oil pressure sender and a second oil pressure hole for accessory use.
Fits VW TDI model BEW, BHW and ALH engines and possibly other VW engines.
$219.00 CAD
This 1.9L TDI water outlet fitting in the same depth as the tandem pump and just has the rad, heater and temp sender outlets.
Very compact when fighting firewall clearance in a TDI conversion.
$49.00 CAD
This kit includes both left and right engine mount parts.
Just weld them up at the angle you need.
It has the correct spacing to align with holes in the ALH and newer 1.9L and 2L TDI . These are the same parts that we use to build our custom mounts.
$125.00 CAD
Accessory drive relocation plate with idler, belt and hardware.
This kit allows the accessory drive bracket on BEW engines to be moved up 6" for added clearance on the A/C compressor and Power Steering pump.
It puts the top of alternator slightly below the top of the intake manifold.
Some modification of the stock accessory bracket is required.
Only works with BEW code engines, not ALH.
$459.00 CAD
This kit includes the parts to build the frame side of your custom mounts.
It includes the 1/2" steel plates with 1/4" steel gussets. From the frame side to the outer edge is 4" and they are about 3.5" wide.
Also included are the rubber mounts and hardware.
$159.00 CAD
This kit includes the parts to build the frame side of your custom mounts.
It includes the 1/4" steel plates with 1/4" steel gussets and the fluid mounts.From the frame side to the outer edge of the fluid mount is 4 3/8", they are about 5" wide and about 3 1/4" tall.
These fluid mounts offer much more vibration control than the rubber mounts in the TDC 216 mount kit but take up much more space.
$159.00 CAD